1. Assess the Damage: Identify areas with peeling, chipping, or fading paint.
2. Clean the Surface: Wash the affected areas with soap and water, and dry thoroughly.
3. Sand the Area: Lightly sand the damaged paint to remove any rust or rough edges.
4. Apply Primer: Use a primer suited for automotive applications to prepare the surface for painting.
5. Repaint: Apply the appropriate color-matched paint in thin, even coats. Allow each coat to dry completely before applying the next.
6. Clear Coat: Finish with a clear coat to protect the new paint and add shine.
7. Polish: Once the paint has cured, polish the area to blend it with the original paint.

For detailed instructions and tips on automotive painting, consult our manual to ensure a professional finish.

1. Inspect the Rust: Determine the extent of the rust damage and whether it's surface rust or has penetrated through the metal.
2. Remove Rust: Use a wire brush or sandpaper to remove the rusted areas. For severe rust, consider using a rust remover or grinder.
3. Clean and Dry: Thoroughly clean the area with water and a degreaser. Ensure the surface is completely dry.
4. Apply Rust Inhibitor: Treat the cleaned area with a rust-inhibiting primer to prevent further corrosion.
5. Patch and Seal: Use a body filler or metal patch to repair any holes or deep rust. Smooth the surface and allow it to cure.
6. Paint and Protect: Prime and paint the repaired area to match the original color. Apply a rust-proofing sealant to protect the repair.

Our manual provides step-by-step guidance on rust repair and prevention to help you maintain your vehicle’s condition.

1. Check Spark Plugs: Inspect the spark plugs for wear or fouling. Replace any damaged or worn plugs.
2. Examine Ignition Wires: Ensure the ignition wires are securely connected and in good condition. Replace any damaged wires.
3. Inspect Fuel System: Check the fuel filter and fuel injectors for blockages or malfunctions. Replace or clean as needed.
4. Verify Engine Timing: Ensure that the engine timing is correctly set. Adjust if necessary.
5. Scan for Error Codes: Use an OBD-II scanner to check for any error codes that could indicate specific issues.
6. Consult a Mechanic: If the problem persists, a professional diagnosis may be required to address underlying issues.

For comprehensive troubleshooting and repair steps for engine issues, refer to our detailed manual.

1. Locate the Leak: Identify the source of the leak by inspecting the engine and transmission for oil or fluid drips.
2. Tighten Seals and Bolts: Check and tighten any loose seals or bolts that may be causing the leak.
3. Replace Gaskets: If leaks persist, replace any worn or damaged gaskets or seals.
4. Check Fluid Levels: Ensure that fluid levels are appropriate and top off if needed.
5. Monitor for Leaks: After repairs, monitor the area to ensure the leak has been resolved.

Detailed instructions on addressing engine and transmission leaks can be found in our workshop manual.

1. Regular Servicing: Follow the recommended service intervals for oil changes, filter replacements, and other routine maintenance.
2. Inspect and Clean: Regularly inspect the vehicle for signs of wear, rust, or damage. Clean and address any issues promptly.
3. Keep Records: Maintain a service history to track repairs and routine maintenance.
4. Protect the Vehicle: Use a car cover or garage to protect your vehicle from environmental damage.

For a comprehensive maintenance schedule and best practices, our manual offers detailed advice to keep your Cortina Super in top condition.