2006 Ford Focus C-Max 1.8 TDCi LX – Workshop Service & Repair Manual

1. Check Transmission Fluid: Ensure that the transmission fluid is at the correct level and in good condition. If it's low or dirty, replace it with the recommended fluid.
2. Inspect for Leaks: Look for any signs of leakage around the transmission. Address any leaks immediately.
3. Perform a Transmission Flush: If the fluid is contaminated, a transmission flush may be necessary. Follow the manual's procedure for flushing and refilling.
4. Check for Error Codes: Use an OBD-II scanner to check for any transmission-related error codes and follow the troubleshooting steps outlined in the manual.

Our manual provides detailed instructions on diagnosing and repairing transmission issues, ensuring your vehicle operates smoothly.

1. Inspect Turbocharger: Check for any visible damage or loose connections around the turbocharger.
2. Check for Oil Supply: Ensure that the turbocharger is receiving adequate oil supply. Low oil levels can lead to turbo failure.
3. Examine Hoses: Inspect the turbo hoses for cracks or leaks, as these can affect performance.
4. Run Diagnostic Tests: Use a diagnostic tool to check for any turbocharger-related error codes and follow the manual’s recommended repair procedures.

Our manual includes comprehensive troubleshooting steps for turbocharger issues, helping you restore optimal performance.

1. Test Alternator Output: Use a multimeter to measure the alternator’s output voltage. It should be within the specified range.
2. Check Wiring: Inspect the wiring and connections to the alternator for any signs of wear or damage.
3. Replace Faulty Components: If the alternator is not functioning properly, it may need to be replaced. Follow the manual’s steps for removing and installing a new alternator.
4. Verify Charging System: Ensure that the entire charging system is functioning correctly after replacement.

Our manual provides detailed instructions for diagnosing and replacing a faulty alternator, ensuring reliable electrical performance.

1. Check for Error Codes: Use an OBD-II scanner to identify any error codes that triggered limp-home mode.
2. Inspect Engine Components: Examine key engine components such as sensors, wiring, and connections for issues.
3. Reset the ECU: Sometimes, resetting the engine control unit (ECU) can resolve limp-home mode. Follow the manual’s instructions for resetting.
4. Address Identified Issues: Follow the troubleshooting steps outlined in the manual to address any issues identified by the error codes.

Our manual offers step-by-step guidance on diagnosing and resolving limp-home mode issues to restore normal operation.

1. Clean the Area: Thoroughly clean the chipped area to remove any dirt or debris.
2. Apply Touch-Up Paint: Use touch-up paint that matches your vehicle’s color to fill in the chips. Follow the manual’s instructions for application techniques.
3. Sand and Polish: Once the paint is dry, gently sand the area and polish it to blend with the surrounding paint.
4. Protect the Repair: Apply a layer of clear coat over the repaired area to protect the paint.

Our manual includes detailed instructions for repairing and maintaining your vehicle’s exterior, helping you keep it in excellent condition.