1977 Ford Capri II 1300 L – Workshop Service & Repair Manual

1. Inspect the Rust Areas: Start by examining the sills, door jambs, and floors for rust damage.
2. Remove Rust: Use a wire brush or sandpaper to remove the rust. For heavier rust, you may need a rust remover or grinder.
3. Treat the Metal: Apply a rust-inhibiting primer to the affected areas to prevent further rusting.
4. Apply Undercoating: For added protection, apply an undercoating to the treated areas.
5. Repaint: Once the primer is dry, paint over the area with a matching color.

Our manual provides detailed steps and illustrations to guide you through the rust repair process effectively.

1. Locate the Leak: Identify the source of the leak by checking around the water pump area.
2. Drain the Coolant: Before removing the water pump, drain the coolant from the radiator.
3. Remove the Water Pump: Unscrew and remove the water pump from the engine.
4. Replace Gasket or Seal: Replace the gasket or seal that may be causing the leak.
5. Reinstall the Water Pump: Attach the new gasket or seal, reinstall the water pump, and refill the coolant.

Our manual includes diagrams and detailed instructions for diagnosing and fixing oil leaks from the water pump.

1. Check Timing Gear: Inspect the timing gear for wear or damage.
2. Align Timing Gears: Make sure the timing gears are correctly aligned according to the manufacturer's specifications.
3. Replace Timing Gear: If damaged, replace the timing gear with a new one.
4. Adjust Timing: After replacing the gear, adjust the timing to ensure proper engine operation.
5. Test Engine: Start the engine and verify that it runs smoothly.

Our manual provides step-by-step procedures for checking and replacing timing gears, along with timing adjustments.

1. Clean the Carburetor: Remove the carburetor and clean it thoroughly using a carburetor cleaner.
2. Check for Blockages: Inspect for any blockages in the jets or passages.
3. Adjust Mixture and Idle: Adjust the fuel-air mixture and idle settings according to the specifications.
4. Inspect for Leaks: Check for any fuel leaks around the carburetor.
5. Reinstall and Test: Reinstall the carburetor and test the vehicle to ensure proper performance.

The manual includes comprehensive instructions for carburetor cleaning and adjustments.

1. Check Coolant Level: Ensure the coolant level is adequate.
2. Inspect Radiator: Check for blockages or leaks in the radiator.
3. Test the Thermostat: Test the thermostat to ensure it's opening at the correct temperature.
4. Inspect the Water Pump: Ensure the water pump is functioning properly.
5. Check for Air Pockets: Bleed the cooling system to remove any trapped air.

Our manual provides detailed troubleshooting steps and maintenance tips for addressing overheating problems.