1977 Ford Capri II 2000 (V6) S – Workshop Service & Repair Manual

1. Check the Battery: Ensure the battery is fully charged and in good condition.
2. Inspect the Fuel Pump: Listen for the fuel pump's sound when turning the key. If it’s not functioning, it may need replacing.
3. Examine the Fuel Filter: A clogged fuel filter can restrict fuel flow. Replace the filter if it's dirty.
4. Inspect the Spark Plugs: Worn or fouled spark plugs can cause starting issues. Replace them if necessary.
5. Test the Cold Start Injector: Ensure the cold start injector is working correctly.

For a detailed guide on troubleshooting and fixing cold-start issues, our manual provides step-by-step instructions.

1. Clean the Carburettor: Remove and clean the carburettor using a carburettor cleaner.
2. Check for Leaks: Inspect for fuel leaks around the carburettor and fix any leaks.
3. Adjust the Air-Fuel Mixture: Ensure the air-fuel mixture is properly adjusted. Refer to the specifications in the manual.
4. Inspect the Carburettor Gaskets: Replace any worn or damaged gaskets.

Our manual provides detailed procedures for cleaning and adjusting the carburettor.

1. Identify the Source: Use a clean cloth to locate the source of the leak. Common areas include the oil pan gasket and valve cover gaskets.
2. Replace Gaskets: If the gaskets are damaged, replace them.
3. Check for Cracks: Inspect the oil pan and other components for cracks or damage.
4. Tighten Bolts: Ensure that all bolts and screws are properly tightened.

Our manual includes specific instructions for locating and fixing oil leaks.

1. Inspect Fuses: Check and replace any blown fuses in the fuse box.
2. Test Battery Connections: Ensure battery terminals are clean and tightly connected.
3. Check Wiring: Look for damaged or corroded wires and repair or replace as needed.
4. Examine Electrical Components: Test components such as the alternator and starter motor.

Our manual offers comprehensive troubleshooting steps and wiring diagrams.

1. Inspect for Rust: Thoroughly check all body panels for rust spots.
2. Remove Rust: Use a wire brush or sandpaper to remove rust from affected areas.
3. Apply Rust Converter: Apply a rust converter to neutralize any remaining rust.
4. Prime and Paint: Apply a primer followed by paint to protect the metal.

Our manual provides tips on rust removal and prevention.