1978 Ford Capri II 1300 GL (low compr.) – Workshop Service & Repair Manual

1. Inspect the Area: Begin by thoroughly inspecting the fenders and rockers for rust spots.
2. Clean the Surface: Use a wire brush to remove loose rust and debris. Sand the area with coarse sandpaper to expose clean metal.
3. Apply Rust Converter: Apply a rust converter to neutralize any remaining rust. Follow the manufacturer’s instructions for application.
4. Prime and Paint: Once the rust converter is dry, apply a rust-inhibiting primer, then top it with paint to match your vehicle’s color.
5. Protect and Maintain: Regularly clean and wax the area to prevent future rusting.

For detailed repair procedures and additional maintenance tips, consult our Workshop Manual for the 1978 Ford Capri II 1300 GL (Low Compression).

1. Check the Battery: Ensure the battery terminals are clean and tightly connected. Test the battery with a multimeter to ensure it’s fully charged.
2. Inspect Fuses and Relays: Check for any blown fuses or malfunctioning relays. Replace them as necessary.
3. Examine Wiring: Look for any damaged or frayed wires. Repair or replace wiring as needed.
4. Test Components: Use a multimeter to test electrical components like the alternator and starter motor for proper functionality.
5. Seek Professional Help: If the problem persists, consult a professional electrician or refer to the wiring diagrams in your manual.

Our manual provides in-depth troubleshooting guides and wiring diagrams to assist you with electrical issues.

1. Inspect for Leaks: Check for fuel leaks around the carburetor. Tighten any loose bolts and replace gaskets if needed.
2. Clean the Carburetor: Remove the carburetor and clean it with carburetor cleaner, paying special attention to jets and passages.
3. Adjust Settings: Adjust the idle mixture and speed settings as per the specifications in your manual.
4. Check for Blockages: Ensure that the fuel filter is not clogged and the fuel lines are clear.
5. Reassemble and Test: Reassemble the carburetor and test the engine performance. Make further adjustments if necessary.

Our manual includes detailed instructions for carburetor maintenance and adjustments to keep your Capri II running smoothly.

1. Locate the Leak: Identify the source of the leak, typically from seals, gaskets, or the transmission pan.
2. Check Fluid Levels: Ensure the transmission fluid is at the proper level. Top up if necessary.
3. Inspect Seals and Gaskets: Replace any worn or damaged seals and gaskets to stop the leak.
4. Repair or Replace Parts: If the transmission pan is damaged, either repair it or replace it.
5. Test and Monitor: After repairs, test drive the vehicle and monitor for any further leaks.

Refer to our manual for detailed procedures on repairing transmission leaks and maintaining proper fluid levels.

1. Check Coolant Levels: Verify that the coolant level is adequate. Top up if necessary.
2. Inspect for Leaks: Examine the radiator, hoses, and water pump for any signs of leaks. Replace any damaged components.
3. Flush the System: Perform a coolant flush to remove any debris and old coolant from the system.
4. Check the Thermostat: Ensure the thermostat is functioning correctly and replace it if needed.
5. Test the Radiator Cap: Make sure the radiator cap is in good condition and properly sealed.

Our manual provides comprehensive instructions for diagnosing and fixing cooling system issues to keep your Capri II running efficiently.