1978 Ford Capri II 1600 L – 2nd Gen (II) – Workshop Service & Repair Manual

1. Inspect the Rust: Check all fenders and rockers for rust damage.
2. Remove Rust: Use a wire brush or grinder to remove the rusted areas. Sand the surface smooth.
3. Treat the Metal: Apply a rust converter or primer to prevent further rusting.
4. Repair: Use body filler to repair any holes or deep rust areas.
5. Paint: Prime and paint the repaired areas to match the car’s color.

For detailed steps and maintenance tips, refer to our comprehensive workshop manual.

1. Check Fuses: Inspect and replace any blown fuses in the fuse box.
2. Inspect Wiring: Look for damaged or loose wiring connections.
3. Test Components: Use a multimeter to test electrical components like the alternator and battery.
4. Repair Faults: Replace faulty components or repair wiring as necessary.
5. Consult Wiring Diagrams: Use the manual’s wiring diagrams for detailed troubleshooting.

Our manual offers extensive electrical troubleshooting guides to help you resolve issues.

1. Check Fuel Supply: Ensure there is adequate fuel in the tank and no blockages in the fuel lines.
2. Inspect Carburetor: Remove and clean the carburetor, checking for clogs or wear.
3. Adjust Settings: Follow the manual to adjust idle speed and mixture settings.
4. Replace Parts: If necessary, replace worn gaskets or components.
5. Reassemble and Test: Reassemble the carburetor and test the engine performance.

Our manual includes detailed carburetor maintenance and adjustment procedures.

1. Identify Leak Source: Check where the transmission fluid is leaking, such as seals or gaskets.
2. Replace Seals: Replace any worn or damaged seals and gaskets.
3. Check Fluid Levels: Ensure the transmission fluid is at the correct level.
4. Inspect Transmission Pan: Tighten bolts or replace the transmission pan gasket if needed.
5. Test Drive: After repairs, test drive the vehicle to ensure the leak is resolved.

For step-by-step repair instructions, consult our detailed service manual.

1. Check Coolant Levels: Ensure the coolant level is adequate and top up if necessary.
2. Inspect Hoses: Look for leaks or damage in coolant hoses and replace them if needed.
3. Test Radiator: Check for blockages or leaks in the radiator.
4. Replace Thermostat: If overheating persists, replace the thermostat.
5. Flush System: Perform a coolant flush to remove any debris or corrosion.

Our manual provides a comprehensive guide on cooling system maintenance and repairs.