1974 Ford Capri II 2000 GT automatic – Workshop Service & Repair Manual

1. Inspect Regularly: Check for rust in common areas like wheel wells, underbody, and around doors.
2. Clean Thoroughly: Wash affected areas with a rust remover solution.
3. Sand the Rust: Use sandpaper or a wire brush to remove the rust.
4. Apply Primer: Use a rust-inhibiting primer to prevent future rusting.
5. Paint the Area: Apply matching paint and a clear coat for protection.

Our manual provides detailed steps for rust removal and prevention, ensuring your Capri II 2000 GT remains rust-free.

1. Check the Battery: Ensure it's fully charged and terminals are clean.
2. Inspect Wiring: Look for frayed or damaged wires and replace as needed.
3. Test the Alternator: Use a multimeter to check if the alternator is working correctly.
4. Replace Fuses: Check for and replace any blown fuses.
5. Verify the Ignition System: Ensure all components, including the ignition coil, distributor, and spark plugs, are functioning properly.

Our manual includes detailed troubleshooting guides for electrical issues, helping you maintain a reliable electrical system.

1. Inspect Fuel Lines: Check for leaks or damage in the fuel lines.
2. Clean the Fuel Filter: Replace or clean the fuel filter to ensure proper fuel flow.
3. Check the Fuel Pump: Test the fuel pump for proper operation and replace if necessary.
4. Examine the Carburetor: Clean the carburetor and adjust it as needed.
5. Inspect Fuel Injectors: Ensure fuel injectors are functioning correctly and clean them if clogged.

Refer to our manual for a comprehensive guide on diagnosing and fixing fuel system problems.

1. Inspect Suspension Components: Check shocks, struts, and springs for wear or damage.
2. Replace Worn Parts: Replace any worn or damaged suspension components.
3. Align the Wheels: Ensure proper wheel alignment to prevent uneven wear.
4. Check Bushings: Inspect and replace worn bushings.
5. Verify Ball Joints: Ensure ball joints are in good condition and replace if necessary.

Our manual provides step-by-step instructions for maintaining and repairing your vehicle’s suspension system.

1. Check Brake Fluid: Ensure the brake fluid level is adequate and top it up if needed.
2. Inspect Brake Pads: Examine brake pads for wear and replace them if they are thin.
3. Examine Brake Discs: Look for cracks or warping in the brake discs and replace if necessary.
4. Bleed the Brakes: Remove any air from the brake lines by bleeding them.
5. Check Brake Lines: Inspect for leaks or damage and repair or replace as needed.

Our manual includes detailed instructions for troubleshooting and repairing brake system issues.