1977 Ford Capri II 1600 L – Workshop Service & Repair Manual

1. Check the Battery: Ensure your battery is fully charged and in good condition. Replace if necessary.
2. Inspect Spark Plugs: Worn or fouled spark plugs can make starting difficult. Remove and inspect each plug, and replace if they are dirty or worn.
3. Check the Ignition System: Examine the ignition coil, distributor cap, and ignition wires for any signs of wear or damage. Replace any faulty components.
4. Adjust the Choke: If your carburettor has a manual choke, make sure it’s functioning properly and adjusted for cold weather starts.

Our workshop manual provides detailed instructions on troubleshooting and fixing cold-starting problems, ensuring your Capri II starts smoothly in any weather.

1. Inspect the Camshaft: Check for wear or damage on the camshaft lobes. If they’re worn, replacing the camshaft may be necessary.
2. Adjust Valve Clearances: Incorrect valve clearances can cause cam follower noise. Use a feeler gauge to measure and adjust the clearances according to the specifications in our manual.
3. Replace Worn Followers: If the cam followers themselves are worn, replace them with new ones to eliminate the noise.

Our manual offers precise guidance on inspecting and adjusting the camshaft and cam followers, helping you restore quiet, smooth engine operation.

1. Clean the Carburettor: Dirt and deposits can clog the carburettor jets. Remove the carburettor and clean all parts thoroughly with a carburettor cleaner.
2. Adjust the Mixture: Incorrect fuel-air mixture can cause rough idling and poor acceleration. Adjust the mixture screws to achieve the correct balance.
3. Check the Float Level: A misadjusted float can cause flooding or fuel starvation. Adjust the float level as needed.

With our workshop manual, you’ll find step-by-step instructions on carburettor maintenance and adjustment, ensuring optimal engine performance.

1. Identify the Source: Check common leak points, including the valve cover gasket, oil pan gasket, and front and rear main seals.
2. Replace Gaskets and Seals: If you find a leak, replace the gasket or seal that’s causing the issue. Be sure to clean the area thoroughly before installing the new part.
3. Check Oil Pressure: High oil pressure can cause leaks. Verify that your oil pressure is within the recommended range.

Our manual provides detailed procedures for identifying and fixing oil leaks, helping you keep your engine clean and leak-free.

1. Check the Fuses: Start by checking all the fuses in the fuse box. Replace any blown fuses.
2. Inspect Wiring: Look for frayed or damaged wires, especially in areas where the wiring is exposed to heat or movement. Repair or replace damaged wires.
3. Test the Alternator and Battery: Use a multimeter to test the voltage output of the alternator and the charge level of the battery. Replace either if they’re not functioning correctly.

Our workshop manual includes comprehensive wiring diagrams and troubleshooting guides to help you resolve any electrical issues quickly and effectively.