1978 Ford Capri 1.6 L automatic – Workshop Service & Repair Manual

1. Inspect the affected areas thoroughly to identify the extent of the rust.
2. Sand down the rusted spots to bare metal using sandpaper or a wire brush.
3. Apply a rust converter to neutralize the rust and prevent further corrosion.
4. Prime the area with a rust-resistant primer.
5. Paint the repaired sections with matching automotive paint and seal it with a clear coat.

To ensure rust issues are properly handled, refer to our detailed manuals for preventive measures and in-depth repair instructions.

1. Check the battery for any signs of corrosion or wear. Clean the terminals if necessary.
2. Inspect the fuses to see if any are blown and replace them as needed.
3. Test the alternator to ensure it's charging the battery properly.
4. Examine the wiring for any loose connections, frayed wires, or damaged insulation.
5. Replace any faulty components, such as relays or switches.

For a complete guide to diagnosing and fixing electrical issues, our manuals offer step-by-step instructions and detailed wiring diagrams.

1. Check the fuel lines for blockages or leaks and ensure fuel is reaching the carburetor.
2. Remove the carburetor and clean it thoroughly, paying attention to jets and passages.
3. Replace any worn or damaged gaskets and seals.
4. Adjust the idle mixture and speed screws according to the manufacturer’s specifications.
5. Reinstall the carburetor and test the engine for smooth operation.

Our manuals provide detailed diagrams and instructions to help you repair and maintain your carburetor effectively.

1. Identify the leak by inspecting the transmission pan, seals, and gaskets.
2. Drain the transmission fluid and remove the pan if necessary.
3. Replace the faulty gasket or seal that is causing the leak.
4. Reassemble the transmission, ensuring all bolts are torqued to the correct specifications.
5. Refill with the recommended transmission fluid and check for any further leaks.

For comprehensive guidance on transmission maintenance and repairs, our manuals cover all aspects in detail.

1. Inspect the radiator for any signs of leaks or blockages.
2. Check the coolant levels and refill if necessary.
3. Examine the thermostat to ensure it opens and closes properly.
4. Test the water pump for any signs of wear or failure.
5. Flush the cooling system to remove any debris or sediment.

Our manuals provide detailed procedures for maintaining and repairing the cooling system, ensuring your engine runs smoothly.