1978 Ford Capri 1.6 L (low compr.) automatic – Workshop Service & Repair Manual

1. Inspect: Examine sills, door jambs, and floors for signs of rust.
2. Clean: Remove rust with a wire brush and sandpaper.
3. Treat: Apply a rust converter to neutralize the rust.
4. Prime and Paint: Use a primer and paint designed for metal to protect the treated areas.
5. Seal: Ensure all seams are sealed with anti-rust sealant.

For a comprehensive guide on dealing with rust, consult our manual for detailed steps and tips.

1. Diagnose: Use a multimeter to check for power and continuity in the electrical circuits.
2. Inspect: Examine wiring for damage or loose connections.
3. Replace: Swap out faulty fuses, relays, or connectors as identified.
4. Repair: Fix or replace damaged wiring and connectors.
5. Test: Verify that all electrical systems are functioning properly.

Our manual provides extensive troubleshooting tips for electrical issues, helping you ensure all components are working correctly.

1. Check: Inspect the fuel filter for clogs and replace if necessary.
2. Clean: Remove and clean the carburetor to eliminate blockages.
3. Test: Ensure the fuel pump is operating correctly and delivering adequate pressure.
4. Inspect: Look for leaks in the fuel lines and repair or replace as needed.
5. Adjust: Fine-tune the carburetor settings for optimal performance.

Our manual includes detailed procedures for servicing and troubleshooting the fuel system.

1. Inspect: Check shock absorbers, struts, and bushings for signs of wear or damage.
2. Replace: Swap out worn shock absorbers or struts.
3. Repair: Replace any damaged bushings or suspension components.
4. Align: Have the vehicle’s alignment checked and adjusted as needed.
5. Test Drive: Ensure the ride quality and handling are restored.

For complete suspension repair and maintenance procedures, refer to our detailed manual.

1. Check: Ensure coolant levels are adequate and top up if necessary.
2. Inspect: Look for leaks in the cooling system and repair them.
3. Flush: Perform a coolant flush to remove debris and old coolant.
4. Test: Check the thermostat and replace it if it's not opening properly.
5. Inspect: Ensure the radiator and cooling fan are functioning correctly.

Our manual provides thorough guidance on preventing and addressing engine overheating issues.