1978 Ford Capri II 1300 GL – Workshop Service & Repair Manual

1. Inspect the Area: Thoroughly check the fenders and rockers for signs of rust. Use a wire brush to remove loose rust.
2. Sand the Rust: Sand the affected areas with sandpaper or a sanding disc to remove any remaining rust and create a smooth surface.
3. Apply Rust Converter: Apply a rust converter to the cleaned surface to neutralize any remaining rust.
4. Prime and Paint: After the rust converter has dried, apply a primer followed by touch-up paint to protect against future rust.
5. Seal: Use a rust-inhibiting sealant to protect the repaired areas from moisture.

For more detailed instructions and tips on rust repair, consult our manual. Download it now to get the complete guide.

1. Check the Battery: Ensure the battery terminals are clean and tight. Test the battery voltage.
2. Inspect Fuses: Check the fuse box for any blown fuses and replace them with the correct rating.
3. Test Wiring: Examine wiring connections for wear or damage. Repair or replace any faulty wires.
4. Inspect Relays: Test and replace any malfunctioning relays.
5. Consult Wiring Diagrams: Refer to the wiring diagrams in the manual to trace and resolve complex electrical problems.

Our manual provides detailed troubleshooting guides and wiring diagrams. Download it today for comprehensive solutions.

1. Clean the Carburetor: Remove and clean the carburetor with a carburetor cleaner to remove any debris or varnish.
2. Adjust the Idle Speed: Follow the manual’s guidelines to adjust the idle speed and mixture screws for optimal performance.
3. Check for Leaks: Inspect for fuel leaks around the carburetor and repair any leaks.
4. Replace Components: If the carburetor is still problematic, consider replacing worn parts like the float, needle, or gaskets.

Our manual provides in-depth carburetor repair procedures. Download it now to get a step-by-step guide.

1. Locate the Leak: Check the transmission fluid level and look for signs of leakage around seals and gaskets.
2. Inspect and Replace Seals: Replace any worn or damaged seals or gaskets.
3. Tighten Bolts: Ensure that all bolts and connections are properly tightened.
4. Top Up Fluid: Refill the transmission with the correct type and amount of fluid.

Our manual offers detailed procedures for addressing transmission issues. Download it now for more specific instructions.

1. Check the Coolant Level: Ensure the coolant is at the correct level and top it up if necessary.
2. Inspect Hoses: Examine hoses for leaks or wear and replace any damaged hoses.
3. Test the Thermostat: Check if the thermostat is functioning properly and replace it if it's faulty.
4. Flush the Radiator: Perform a radiator flush to remove any blockages or debris.
5. Check the Water Pump: Ensure the water pump is working correctly and replace it if needed.

Our manual contains detailed maintenance tips for the cooling system. Download it now to ensure your system runs smoothly.