1978 Ford Capri II 1600 L automatic – Workshop Service & Repair Manual

1. Regularly inspect areas prone to rust, such as the wheel arches, door sills, and undercarriage.
2. Clean these areas thoroughly, removing any dirt or debris.
3. Apply rust protection spray or wax to vulnerable spots.
4. Treat any existing rust with a rust converter and follow up with primer and paint to seal the area.

For detailed instructions on rust prevention and treatment, refer to our Workshop Service & Repair Manual. It includes step-by-step guidance on how to protect your vehicle from rust damage.

1. Check the battery connections for corrosion and ensure they are tight.
2. Inspect fuses for any signs of damage and replace them if necessary.
3. Test the wiring for continuity using a multimeter, focusing on areas that commonly experience wear and tear.
4. Look for loose or frayed wires and repair or replace them as needed.

Our manual provides in-depth electrical diagrams and troubleshooting steps to help you solve any electrical issues with your Ford Capri.

1. Inspect the carburetor for dirt or debris that could be clogging the jets.
2. Clean the carburetor using a carburetor cleaner, paying attention to all small parts and passages.
3. Adjust the fuel mixture to ensure the engine is running at the correct air-fuel ratio.
4. Replace worn gaskets or seals to prevent air leaks.

For a complete guide to cleaning, adjusting, and repairing your carburetor, consult our Workshop Service & Repair Manual, which includes detailed procedures.

1. Inspect the shock absorbers for leaks or damage and replace them if necessary.
2. Check the suspension bushings for wear and tear, and replace any that are cracked or worn.
3. Examine the springs for sagging or damage, and replace them if needed.
4. Ensure all suspension components are properly lubricated to reduce friction and wear.

Our manual offers a detailed guide on suspension maintenance and repairs, helping you restore the smooth ride of your Ford Capri.

1. Check the brake pads and replace them if they are worn down.
2. Inspect the brake discs for signs of warping or excessive wear and replace them if necessary.
3. Bleed the brake lines to remove any air that could be causing a spongy brake pedal.
4. Examine the brake fluid level and top it off if it's low, using the recommended type.

For detailed instructions on brake system maintenance and repairs, including how to safely perform these tasks, refer to our Workshop Service & Repair Manual.