2004 Ford Mondeo (4-dr) 1.8 SCi Ghia – Workshop Service & Repair Manual

• Inspect the Throttle Body: Check for carbon deposits and clean if necessary.
• Examine the Spark Plugs: Ensure they are clean and properly gapped; replace if worn.
• Check the Idle Air Control Valve: Test for proper operation and clean or replace it if needed.
• Inspect Vacuum Leaks: Use a vacuum gauge to identify any leaks in the intake system.

For detailed instructions, refer to the manual’s engine diagnostics section.

• Check Transmission Fluid: Ensure it’s at the correct level and free of debris.
• Inspect the Clutch Plates (if manual): Look for signs of wear or damage.
• Scan for Error Codes: Use an OBD-II scanner to check for transmission-related codes.
• Inspect Solenoids: Test and replace any faulty shift solenoids.

Detailed guidance can be found in the transmission section of the manual.

• Inspect Weather Seals: Check door and window seals for damage or misalignment.
• Clean Drain Channels: Ensure sunroof and door drain channels are not clogged.
• Examine HVAC System: Check for leaks in the heater core or AC condenser.
• Seal Gaps: Use a silicone sealant for minor gaps around fixtures.

The manual provides comprehensive instructions for water leak diagnosis and repair.

• Check Brake Fluid: Ensure the fluid is at the correct level and not contaminated.
• Bleed the Brakes: Remove air from the brake lines to restore proper pressure.
• Inspect Brake Hoses: Look for cracks, leaks, or other damage.
• Test the Master Cylinder: Replace if it’s not maintaining adequate pressure.

The manual contains step-by-step brake system troubleshooting.

• Inspect the Radiator: Check for clogs or leaks.
• Test the Thermostat: Replace if it’s stuck or malfunctioning.
• Check Coolant Levels: Ensure proper coolant levels and that it’s free of contaminants.
• Inspect Fans and Belts: Ensure the cooling fans and drive belts are functioning correctly.

Consult the cooling system section of the manual for detailed steps.